to if the engine is cold;
to if the engine is war
m(even if the engine has already run but is still cold);
rm start).
top and hold it in position.
nd firmly press the cut-off saw against ground ,
the starter rope ort distance,
kly and strongly.
ngth
system.
place slowly.
ht up and down through the rope guide bushing to
to if the engine is warm (latched position for wa
. Pull the throttle trigger (3) backward as far as the s
. Press down the full throttle lock button (4).
. Release the throttle trigger (3).
. Hold the front handle with left hand a
place the right foot on the carburetor box cover.
. Holding the starter grip (5) securely, slowly pull out
27
for a sh
and then pull it through quic
Note: a. Starter rope is 1.15m long, do not pull the rope out more than it’s le
otherwise it may break or cause damage to the starting
b. Do not let go of the starter grip.
c. After pulling, guide the rope back into
d. Pull the rope only straig
To Next Page
Loading...