● r cover (1) and screw in the four screws (2).
ing pawl (Ref. Fig. 13)
Refit the flywheel/starte
4. Rep
The w
the an gaging and disengaging the
start c
cover (1) in succession.
lac
pa l functions as a link between the rope rotor and
kshaft (by en
cr
er
● Unscrew the screws (2) on the flywheel/starter
cover (1) and remove the cover from the
engine unit.
up) and needs to be replaced if damaged.
● Remove the spring clip (8), Remove the
damaged pawl (9).
Replace a new
● pawl.
● Refit the spring clip (8) and the flywheel/starter
38
To Next Page
Loading...