●
e it with a simple knot. (and fitting the knot into the clearance
(10)).
Thread the rope through the rope rotor (7) (enter from the hole on the rotor
groove) and secur
Wind the rope around the rope rotor (7) clockwise until there is a length of ●
300mm left unwound..
● Slip the rope rotor onto the starter post (6) and turn it back and forth a little until
the anchor loop of the rewind spring engages.
Replace the pawl (9) i
37
● n the rope rotor.
● Press the spring clip (8) onto the starter post and over the peg of the pawl with
a screwdriver.
Note: The spring clip must point counter-clockwise.
● To tension the rewind spring, first guide the rope through the notch on the edge
of the rope rotor and form a loop, use it to turn the rope rotor 4-5 times
counter-clockwise.
Then hold the rope rotor tight, pull out the twisted rope and untangle it.
Relea
●
● se the rope rotor, slowly let go of the starter rope so that it is wound up on
the rope rotor.
To Next Page
Loading...