starting. In this case, make the standard setting
first as instructed in (a), then turn the idle speed adjusting screw LA (see Fig 9,)
until the blade starts to
, which is not good
this idling
stops running. Then
3. Adjusti
The blade
To adjust
positioning ove the blade guard
to a de ten the
inside the lower hole of carburetor seal cover clockwise
run. Then turn the screw LA backwards
(counter-clockwise) 1/4 circle (90°).
●
f
If the idling speed is too high, the blade will run at idling speed
or the Cut-off saw. In case, make standard setting first, then turn the
speed adjusting screw LA counter-clockwise until the blade
turn the screw LA 90°further (counter-clockwise).
ng blade guard (Ref. Fig.10)
guard (1) deflects sparks from the operator.
it’s position, loosen the blade guard
knob (2) first, then m
sired position by hand. Finally retigh
To Next Page
Loading...