3. Operation (Ref. Fig.7)
. The blade will not run when the engine idles.
. When the cut-off saw is ready for actual cutting work, gently pull the throttle trigger (3)
backward to accelerate the engine, when the speed is over 3800 rpm, the blade begins
to rotate and speeds up. When the blade speed is up and stable, you can begin to
move the saw slowly toward the object to be cut. After the cutting edge comes in
contact with the object, increase pressure to the saw slowly until the blade is at the
desired depth. curely and move along a straight line to
Fig. 7
29
Finally hold the machine se
complete the cut.
To Next Page
Loading...