Chino DB600 - Model Code

E7
Thermocouple Measuring range Measured accuracy
□□□□ B 0.0 to 1820.0
±0.1% of FS±1digit
For below 0°C,
±0.2% of FS±1digit
Below 400°C: Out of specification
400 to 800°C: ±0.2%FS ±1digit
□□□□ R 0.0 to 1760.0
Below 400°C: ±0.2%FS ±1digit
□□□□ S 0.0 to 1760.0
□□□□ N 0.0 to 1300.0
□□□ K -200.0 to 1370.0
□□□ K -200.0 to 500.0
□□□□ E -200.0 to 900.0
□□□□ J -200.0 to 1200.0
□□□□ T -200.0 to 400.0
□□□□ U -200.0 to 400.0
□□□□ L -200.0 to 900.0
 C(WRe5-WRe26) 0.0 to 2310.0
 W-WRe26 0.0 to 2310.0 Below 400°C: ±0.4% FS ±1digit
 Platinel II 0.0 to 1390.0
□ PtRh40-PtRh20 0.0 to 1880.0 ±0.3% of FS±1digit
Below 400°C: Out of specification
400 to 800°C: ±0.8%FS ±1digit
 Au-Pt 0.0 to 1000.0 ±0.3% of FS±1digit
DC voltage Measuring range
□ ±20mV -20.00 to 20.00
±0.1% of FS±1digit
 ±100mV -100.0 to 100.0
□□□ ±5V -5.000 to 5.000
□□ ±10V -10.000 to 10.000
Resistance thermometer Measuring range
□□ Pt100 -200.0 to 850.0
±0.1% of FS±1digit
□□ Pt100 -200.0 to 200.0
□ JPt100 -200.0 to 649.0
□ JPt100 -200.0 to 200.0
□ Pt50 -200.0 to 649.0
*For inputting direct current 4 to 20mA, attach an external shunt resistor 250Ω (selling separately).
*Accuracy indicates the performance under reference operating condition.
*For thermocouple, the reference junction compensation accuracy is added to the above measured accuracy.
 DB63
Model
code
Control
al
g
orithm
Control
output 1
Control
output 2
Communication
Input/output
Programming
function
Alarm event
output
OP
Power
voltage
specification
DB63 48x48 size
1 PID control
2 Z control
1 ON-OFF pulse output type
3 Current output type
5 SSR drive pulse output type
6 Voltage output type
0 None
0 None
S RS485 + 1 External input point [DI 1]
D 5 External signal input points [DI1 to 5]
― None
P Available
0 None
1
2 Alarm event output points [EV1, 2]
*1
0 None
Refer to code table for adding option
*2
A 100 to 240V AC
*1 Alarm event only functions on mechanical relay, so check for the event function and
D
24V AC／DC
select it.
Measurin
g
ran
g
e table
Model code