Page 20 of 40 IRIS Touch Engineering Manual Version 1.4
Settings
The Settings option is used to configure additional settings required for installation or
additional options that may be added at a later date. Below is a detailed description of
all of these options.
Network Interfaces
This section allows the user to select the communication paths to be used for polling /
alarms on a multipath IRIS Touch dialler. There are up to 2 options as detailed below,
depending on which version of IRIS Touch dialler:
Ethernet
GPRS/3G (Machine to machine data ‘M2M’)
Account Name/Number
Set the account name/number for the IRIS Touch unit on site, as allocated by the
monitoring centre.
ARC IP Address
Set up the external IP address for the monitoring centre receiver (polling engine).
Note: Only the primary/main ARC IP address needs be entered on the dialler as all
backup or alternative IP addresses, for the ARC are downloaded to the IRIS Touch
dialler on the first polling communications.
Dialler IP Address (IRIS Touch 620NG or 640NG)
Allows the user to setup the IP address of the dialler to either automatic (DHCP) or a
fixed IP address. The settings below will either show the IP address received (DHCP
mode) or, if fixed, allow the user to set the IP address, subnet and gateway:
IP Address
Subnet Mask
Gateway
Mac Address (view only)
To Next Page
Loading...