Chiron Iris Touch 600NG - Before You Start

IRIS Touch Engineering Manual Version 1.4 Page 7 of 40
6. Before You Start
Monitoring Centre (ARC)
Make sure that the monitoring centre to which the IRIS Touch device will send alarm signals is equipped with the
appropriate IRIS Secure Apps receiving system. The following information should be obtained from the monitoring
centre.
Dialler account number
Monitoring centre IP address
Ethernet Connection Details
The customer’s Ethernet (LAN) network details are required in order to connect the IRIS Touch. The following
information should be obtained from the customer.
Fixed IP address or DHCP
Fixed 
DHCP 
If using DHCP then the following information will not be required as it
will be assigned by the network.
IP address
Gateway address
Subnet mask address
GPRS/3G SIM Card and Access Point Name
If the installation uses GPRS/3G then a SIM card will be required. The IRIS Touch will also need to be given a GPRS/3G
‘Access Point Name’ (APN) and other possible configurations as shown below. These can be obtained from the SIM
card provider.
Access Point Name (APN)
User Name (USR)
Password (PWD)
SIM Pin