Chord DAVE - Connecting DAVE to Amplification Systems

Chord Electronics
DAVE | Manual
_
To connect DAVE to a preamp,
integrated or power amp, you
should connect the outputs
of DAVE to the inputs of your
preamp, integrated or power
amp;
1) Locate the outputs on the
back of the unit shown below.
2) Paying close attention to the
left and right channels, insert
the cables in to DAVE.
3) Ensure the cables click into
the connectors securely.
4.1 Placement
4.2 Connecting your source to
DAVE
4.3 Connecting a BLU MK II or
Hugo M Scaler to DAVE
4.4 Connecting a preamplifier/
amplifier to DAVE
4.5 Powering DAVE
Connecting a preamplifier/
amplifier to DAVE
4.4
20 // 35
Outputs
WARNING: Read
section 6 before
initiating playback.