Chord DAVE User Manual

Chord Electronics
DAVE | Manual
_
Before connecting DAVE to any
third-party equipment, consult
the manufacturer’s user guide to
confirm compatibility.
When connecting DAVE to any
equipment, make sure that all
devices are o, including DAVE.
Once connected, switch all
equipment on starting with
the source and ending with the
amplification.
Initially, operate DAVE on its
lowest volume setting, gently
increasing to a comfortable
listening level.
Never operate DAVE at excessive
volume levels; permanent hearing
damage and/or loss can occur.
DAVE does not have internal
batteries and, therefore, must
be permanently connected to a
source of power.
The included 10-amp IEC power
cable plugs into DAVE.
Do not disconnect DAVE from
the power cable without first
switching the unit o to avoid
any damage.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Connecting your equipment 1.4
Never disconnect the
power cable during
operation. Only
disconnect when DAVE
is o. If the power cable
is disconnected during
operation, there is a risk
of damage to connected
equipment.
7 // 35

Chord DAVE Specifications

Audio Specifications

frequency response	20Hz to 20kHz
THD + N	127.5dB
channel separation	>125dB @ 1KHz
dynamic range	127.5dB

Digital Inputs and Outputs

digital inputs	4 x 75Ω SP/DIF BNC Coax 44.1KHz - 384KHz
AES balanced XLR input	44.1KHz - 96KHz
plastic fibre optic inputs	2 x TOSlink 44KHz - 192KHz
USB input	44KHz - 768KHz PCM + DSD
analogue outputs	2 x RCA Phono, 2 x Balanced XLR
headphone output at 300 ohm	1% THD 6.8v RMS (154 mW)
headphone output at 33 ohm	1% THD 6.8v RMS (1.4W)

Power and Dimensions

power supply	90V AC - 250V AC auto switching 50 - 60HZ
dimensions	338 x 60 x 145mm (Width x Height x Depth)
weight	7Kg