Chord Ultima - Protection Against Liquids & Heat

Chord Electronics
Ultima | Manual
_
Chord Electronics
Ultima | Manual
_
8 // 30 9 // 30
1.1 Introduction
1.2 Protection against
liquids & heat
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Introduction Protection against
liquids & heat
1.1 1.2
Ultima is the cornerstone
of Chord Electronics’
amplfication, standing as
our ultimate reference amplification -
beaten by none.
Before operation, we strongly advise
that you read this user manual
thoroughly, storing it in a safe place
along with your original receipt of
purchase, in case you should require
assistance in the future.
The Ultima is not protected
against liquids of any kind.
Never place containers of
liquid on Ultima. Never allow Ultima
to come into contact with moisture
or liquids; doing so could result in
electrocution or damage to the Ultima
internal circuitry.
Be aware that liquids, including water
that has dried, can leave minerals
that can aect the PCB and other
components, which could eventually
lead to oxidisation and short-circuiting.
If the Ultima comes into contact with
moisture or liquids, immediately
disconnect from the mains power
supply, and connected equipment, and
contact Chord Electronics for further
advice.
The Ultima has internal thermal
protection that will cut the
power supply if reached.
Never operate the Ultima near sources
of heat or naked flames as this will
decrease the lifespan of the internal
components. It is advised that you do
not operate the Ultima in an area of
direct sunlight or on top of significant
heat- producing devices.
Please be aware that it is entirely
normal for the Ultima to become warm
during use, particularly within a stacked
configuration. If you are concerned
about the temperatures, please switch
the device o and consider a dierent
placement.