Convergence Instruction Sheet 1 of 10
020-100703-01 Rev. 1 (05-2011)
CP4220/4230 Convergence
Instruction Sheet
INTRODUCTION
These instructions explain how to adjust convergence in the CP4220 and CP4230 projectors.
Information provided here supplements the main Convergence Instructions drawing provided inside
the top lid of the projector.
TOOLS REQUIRED
• 2.5 mm driver with heat-shrink tubing (2.0 inch and 6.5 inch lengths), included with projector. One
driver is located on the the high security lid and the other is located in the packaging.
INSTRUCTIONS
Convergence adjustment must be performed by a qualified service technician.
ACCESSING THE LIGHT ENGINE
Remove the top lid to access to the light engine and liquid cooling system compartments.
To Next Page
