Ultra short throw lens
installation
The ultr
a short throw lens—0.36 UST GS (P/N: 140-133108-XX)—allows you to position your projector
as close as possible to your screen or display.
Unless otherwise indicated, the 700-GS and 850-GS model is shown for illustration purposes and may
v
ary from your model.
Affected products
The following products are affected:
•
GS Series
Identifying product versions
The Ultra short throw lens kit is designed with two types of installation accessories to fit the different
lens shift modules (LSM) on the projectors. Check the boresight of the projector to identify the version
of the lens shift module. This document provides installation steps for both types of LSMs.
Make sure the projector is turned off before checking the boresight.
Lens shift module Boresight description Projectors
LSM1 Has a lens release button. The
boresight plate is secured with three
screws.
Christie DHD630-GS
Christie DWU630-GS
Christie DHD635-GS
Christie DWU635-GS
Christie DHD850-GS
Christie DWU850-GS
Christie DHD700-GS
Christie DWU700-GS
Christie DHD1075-GS
Christie DWU1075-GS
LSM2 - A Does not have a lens release button.
The boresight plate is secured with
four screws
Christie DHD630-GS
Christie DWU630-GS
Christie DHD635-GS
Christie DWU635-GS
Ultra Short Throw Lens Installation Instruction Sheet 1
020-102569-07 R
ev. 1 (12-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
To Next Page
General
Weight and Dimensions
