INSTALLATION
(1) Place B-pillar trim in position on vehicle.
(2) Engage clips to hold upper trim to B-pillar.
(3) Place shoulder belt turning loop in position on
adjuster.
(4) Install bolt to hold turning loop to shoulder
belt height adjuster.
(5) Install shoulder belt turning loop cover.
(6) Refit weatherstrip.
QUARTER TRIM LOWER (C-PILLAR)
REMOVAL
(1) Remove rear seat cushion and back.
(2) Pull upper quarter trim from panel (Fig. 74).
(3) Remove sill trim as necessary to clear quarter
trim removal path.
(4) Disengage clips attaching lower quarter trim to
inner quarter trim from vehicle.
(5) Remove quarter trim from vehicle.
INSTALLATION
(1) Place quarter trim in position on vehicle.
(2) Engage clips to attach lower quarter trim to
inner quarter panel.
(3) Install upper quarter trim.
(4) Install sill trim.
(5) Install rear seat cushion and back.
QUARTER TRIM UPPER (C-PILLAR)
REMOVAL
(1) Disengage clips holding upper quarter trim to
inner quarter panel (Fig. 74).
NOTE: Start at top forward area of trim and pull
inboard.
(2) Remove seat cushion.
(3) Remove lower seat belt anchor nut.
(4) Slide seat belt through trim panel.
(5) Remove upper quarter trim from vehicle.
INSTALLATION
(1) Slide belt through trim panel.
(2) Place upper quarter trim in position on vehicle.
(3) Engage clips to attach upper quarter trim to
inner quarter panel.
NOTE: Start at lower attachments first and work up.
(4) Install seat belt anchor nut.
(5) Install seat cushion.
FRONT SEAT BELT RETRACTOR
CAUTION: Inspect the condition of the shoulder
belt and lap belt. Replace any belt that is cut,
frayed, torn, or damaged in any way. Also, replace
the shoulder belt if the retractor is either damaged
or inoperative.
Fig. 73 B-Pillar Lower and Upper Trim
1 – SHOULDER HARNESS ADJUSTER
2 – UPPER B-PILLAR TRIM
3 – CLIPS
4 – LOWER B-PILLAR TRIM
5 – B-PILLAR
6 – CLIP
Fig. 74 Lower Quarter Trim
1 – UPPER QUARTER TRIM
2 – QUARTER PANEL
3 – LOWER QUARTER TRIM
4 – DOOR SILL TRIM
23 - 64 BODY LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
