CHRYSLER SERVICE MANUAL
ENGINE—153
INTAKE PUSH RODS!
I EXHAUSTpi
I/-
-mr\
51x978
Fig.
7—Push Rods Installed (FirePower)
fixture Tool C-3209 (SpitFire Engine), Tool
C-3133 (FirePower Engine) to prevent damage
to machined surfaces. Remove exhaust manifold
and gasket, if cylinder head is to be replaced.
6. INSTALLATION OF CYLINDER HEADS
Clean gasket surfaces of cylinder block and
cylinder head. Check all surfaces with a
straightedge if there is any reason to suspect
leakage.
Install exhaust manifold gasket and manifold
on cylinder heads. Install cylinder heads and
new cylinder head gaskets. Coat gaskets with
a suitable sealer. Install push rods as shown
in Figures 6 and 7. Insert cylinder head bolts
into rocker arm support brackets, and place
rocker arm assemblies in position on head, lin-
ing up all push rods to their respective rocker
1x373
Fig.
9—Tightening Cylinder Head Bolts (FirePower)
arms.
Starting at top center, tighten all cylin-
der head bolts to 85 foot-pounds torque, in se-
quence shown in Figures 8 and 9.
Place new valve tappet cover gaskets in po-
sition, and install tappet cover. Tighten bolts
to 50 inch-pounds torque. Install crankcase
breather tube on tappet cover and insert oil
level indicator (dip stick) tube into position.
Install new cylinder head cover gasket and
install cover. Tighten nuts and bolts to 30 inch-
pounds torque. On FirePower engines slide
spark plug tube seals over tubes, and install in
position in heads. Check spark plugs for .035
inch gap and install plugs, being careful not
to drop them on electrodes as this would cause
1/4 INCH DEFLECTION FROM ^STRAIGHT LINE BETWEEN PULLEYS
GENERATOR ADJUSTINGSTRAP BOLT
IDLER PULLEY ADJUSTING BOLT
56x246
Fig.
8—Tightening Cylinder Head Bolts (SpitFire)
Fig 10—Adjustment
of Fan
Belts (FirePower)
(Typical
of
SpitFire)
MyMopar.com
To Next Page
Loading...
