CHRYSLER SERVICE MANUAL
CHRYSLER C-300B—459
Section XVIII
CHRYSLER C-300B
1.
FRONT WHEEL SUSPENSION
The same basic design as used in Model C-72,
in the Front Wheel Suspension Section I.
3.
REAR AXLE DATA AND SPECIFICATIONS
2.
REAR AXLE
A standard or optional rear axle, of the same
basic design as used on Model C-72, with the
exceptions as listed in Data and Specifications.
Type Semi-Floating
Gear Type Hypoid
Ring Gear Diameter 8.75"
Pinion Bearings 2
Type Tapered Roller
Adjustment Solid Washer
Differential Bearings 2
Type Tapered Roller
Adjustment Threaded Adjuster
Drive Gear Pinion Matched Sets
Drive Gear Run-Out .005" Maximum
Drive Gear and Pinion Backlash .006" to .008"
Differential Side Gear Clearance. .004" to .012"
Axle Ratio Standard
With Standard 3-Speed Trans 3.54*
No.
Drive Gear Teeth —
No.
Drive Pinion Teeth —
With PowerFlite 3.54*
No.
Drive Gear Teeth 39
No.
Drive Pinion Teeth 11
Lubrication
Type Recommended Ex. Press. Hypoid
Summer 90
Winter 90
Extreme Cold 80
Capacity 3H pints
Wheel Bearings
Type Tapered Roller
Adjustment Select Shims
Axle End Play 003" to .008"
Road Clearance (full load)
Frame Side Member 5.8"
Rear Axle Clearance 8.4"
Tread (Rear) 59.6"
MyMopar.com
To Next Page
Loading...
