164—ENGINE
CHRYSLER SERVICE MANUAL
FEELER GAUGE
CHAIN CASE COVER
56X224
Fig.
36—Checking to Make 5lire Seal is Properly
Seated
NOTE
It
is
normal
to
find particles
of
neoprene
col-
lected between
the
seal retainer
and
crankshaft
oil slinger.
c. Installing Chain Case Cover
Be sure mating surfaces
of
chain case cover
and cylinder block
are
clean
and
free from
burrs.
Use
a
new gasket, slide chain case cover
over locating dowels
and
tighten bolts 15 foot-
pounds torque.
21.
INSTALLING VIBRATION DAMPER
Refer
to
Figure
37 and
proceed
as
follows.
Place damper
hub key in
slot
in
crankshaft
DUST SEAL
DAMPER
PULLEY
HUB
LOCK WASHER
51x980
RETAINER WASHER
Fig.
37—Vibration Damper Assembly
(Disassembled View)
•:•:!
rtt
DISTRIBUTOR DRIVE GEAR
,
My qp
;
1 qp
Fig.
38—Distributor Drive Gear Installation
and position dust seal
in hub.
Slide
hub and
seal
on
crankshaft. Place installing tool (part
of Puller
set
C-3033)
in
position
and
press
damper
hub on
crankshaft. Slide damper
and
pulley over shaft
and
secure with bolts
and
lockwashers. Tighten bolts
15
foot-pounds
torque. Install damper hub retainer washer and
bolt. Tighten 135 foot-pounds torque.
22.
CAMSHAFT REMOVAL
With intake manifold, tappet cover, push rods,
tappets
and
timing gears removed, remove dis-
tributor. Lift
out
distributor drive gear
and
stub shaft, (Fig. 38). Remove camshaft thrust
plate attaching bolts
and oil
trough, (Fig.
39).
Withdraw camshaft
and
spacer, being careful
CAMSHAFT.
SPACER
CAMSHAFT SPROCKET
BOLT
THRUST PLATE
FUEL PUMP ECCENTRIC
CUP WASHER
56x47
Fig.
39—Camshaft Drive Parts (Disassembled View)
MyMopar.com
To Next Page
Loading...
