Chrysler Windsor C-67 1955 - Assembling the Power Steering Gear

CHRYSLER SERVICE MANUAL
STEERING—247
TOOL
PISTON PIN HOLES
53x821
Fig. 19—Removing Upper Piston Rod
UPPER PISTON ROD
PISTON PIN ASSEMBLY
WIRE HOOK
53x822
Fig. 20—Removing Piston Pin from Upper Piston Rod
RELIEF VALVE PLUG
LOWER PISTON ROD
54x636
Fig. 21—Removing Lower Piston Rod Relief Valve Plug
56x169
Fig. 22—Removing Gear Shaft Bearing with Tool C-3333
ring from housing. Use extreme care when re-
moving lower plugs to prevent cocking. A
cocked plug can result in broken gear housing.
Inspect bearing in gear shaft cover. If bear-
ing rollers are rough or broken, replace cover
and bearing assembly. Remove lower piston rod
seal (lip type) from housing with Tool C-3450
(Fig. 23). The lower rod is supported by a half
bushing. The bushing is friction lit over a dowel
pin.
15. ASSEMBLING THE POWER STEERING
GEAR
a. Assembly of Power Steering Gear Housing
Place new piston rod seal over driver, Tool C-
3395. so that lip will be facing up or to inside
of cylinder when installed. Insert seal aligning
pilot of tool in end of driver and drive lower
piston rod seal into position in gear housing
(Fig. 24).
TOOL
55x173
Fig. 23—Removing Lower Piston Rod Seat
with Tool C-3450
MyMopar.com