cias SIOUX PRO 2 - Page 42

© CIAS Elettronica S.r.l. Ed 1.1
Installation Manual Page 42 of 51 Sioux Pro 2
3.2.1.7 Store Cut Prealarm Events and Signals
It is possible to set if store or not Cut Prealarm Events in the Event Log and Monitor files of the
Sioux-CU-Pro2.
To access this setting, select position 8 of the “function” selector.
- Selecting by tens and unit selectors values 0 and 0 and pushing SET BUTTON, the store
function for Cut Prealarm Events is DISABLED
- Selecting by tens and unit selectors values respectively 0 and 1 and pushing SET BUTTON,
the store function for Cut Prealarm Events is ENABLED
3.2.1.8 Enable / Disable encrypted communication
You can set whether to enable AES128 encryption in communication to IB-SystemIP
To access this function, set the function switch to position A:
- By setting the "tens" switches to "0" and "unit" to 0, the encryption is not active
- By setting the "tens" switches on "0" and "unit" on 1, encryption is activated
Then press SET BUTTON button to activate the setting.
By default the setting is 0 - 0, encryption not active.
3.2.1.9 Enable / Disable the Redundancy
You can set whether to enable redundancy on the LINE1 and LINE2 sensor lines.
To access this function, set the function switch to position B:
- By setting the "tens" switches to "0" and "unit" to 0, the redundancy is not active
- Setting the "tens" switches to "0" and "unit" to 1, activates redundancy
Then press SET BUTTON button to activate the setting.
By default the setting is 0 - 0, redundancy not active.