Installation 2-27
3930 Service Delivery Switch Hardware Installation and Start-up Manual
009-3223-001 Standard Revision E
Copyright
©
2012-2014 Ciena
®
Corporation January 2014
Procedure 2-9
To Remove a Pluggable Optic
Step Action
1 Disable customer traffic for the port.
2 Remove any cabling from the optic.
3 Press or pull on the ejector lever (depending on the type of optic used) and
gently pull the optic out of the slot.
You have removed the pluggable optic. You can now install a different
optic into this port, or install the removed optic into a different port.
Pluggable optic installation instructions are provided in “To Install a
Pluggable Optic” on page 2-26.
WARNING: To prevent ESD damage to electronic components, always use an ESD
wrist strap when handling modules.
CAUTION: Because invisible radiation may be emitted from the aperture of the port
when no fiber cable is connected, avoid exposure to radiation and do not stare into
open apertures.
WARNING: If you are not immediately re-installing another pluggable optic, install a
dust cover in the slot to protect it from ambient dust.
To Next Page
Loading...
