8
Microphone Operation
REV: In standby, press the key programmed as "REV" function to turn-on
or turn off Frequency Revrse function.
HOME: HOME channel switch, in standby press the key programmed as
"HOME" function to switch between HOME
channel and current channel.
MAIN: Main band switch, in standby press the key programmed as
"MAIN" function to choose left band or right
band as Main band.
VFO/MR: Working mode switch, in standby, press the key programmed
as "VFO/MR" function to switch between
channel mode and frequency mode.
SCAN: scan function, in standby, press the key programmed as "SCAN"
function to start channel scan or frequency
scan.
SQL OFF:Turn off Squelch, in standby, press the key programmed as
"SQL OFF" function to turn off squelch, you can hear very weak signal,
repeat the above function to turn on squelch.
TBST: Transmit tone burst, in standby, press the key programmed as
"TBST" function to transmit selected tone
burst. This function is use to wake sleeping
repeater.
CALL OUT: Calling, in standby, press the key programmed as "CALL
OUT" function to transmit pre-programmed
DTMF, 2TONE, 5TONE code.
COMP: Compander function in standby, press the key programmed as
"COMP" to turn on or turn off Compander
function.
SCR: Scrambler function, in standby, press the key programmed as
"SCR" function to turn on or turn off Scrambler function. And choose
optional scrambler groups (from 9 xed groups
and 2 self dened groups).
TONE DEC: Add Optional Signaling, in standby press the key programmed
as"TONE DEC" function to choose DTMF(DT),
2TONE(2T), 5TONE(5T) or OFF.
W/N: Wide or narrow band setup, in standby, press the key programmed
as "W/N" function to choose Wide band,
middle and narrow band.
TALK: In standby status, press programmed
Talk key to enable and disable Talk around
function.
OFF: No function.
To Next Page