8
Microphone Operation
SEND DTMF SIGNALING
MAIN/SUB BAND SWITCHING
FUNCTION OPERATION THROUGH PA-PD KEYS
You can operate the transceiver by keypad or input desired frequency
and channel through the QHM-05 microphone.
Hold the PTT key; input the desired DTMF signaling by the numeric keys.
This transceiver is defaulted on dual receive, in this status, a MAIN icon
will display in the top right corner of the Main band frequency, transmitting
is only available on the Main band. In standby, you can switch Main band
and sub band by the A/B key.
This function is valid only when current channel set with offset frequency.
PRI
：
Add or delete priority channel: In channel mode, press the key
programmed as PRI function to set priority channel, when the LCD
displays
the current channel is set as priority channel. Repeat above
operation, the
disappear, the curent channel
is not set as priority channel.
LOW: Output power setup, in standby, press the key programmed as as
LOW function will change the power level. When LCD displays HIGH, the
transmitting power on current channel is high. When LCD displays MID1,
the transmitting power on current channel is middle1, When LCD displays
MID2, the transmitting power on current channel is middle 2. When LCD
displays LOW, the transmitting power on
current channel is low.
TONE: CTCSS/DCS code setup. In standby, press the key programmed
as TONE function will be able to setup CTCSS/DCS code. When the
LCD displays "ENC" and CTCSS frequency, press the [ UP/DOWN ] key
to choose CTCSS encode. When the LCD displays "ENC", "DEC" and
CTCSS frequency, press the microphone
[ UP/DOWN ] key to choose
CTCSS decode. When the LCD displays
"DCS" and DCS code, press the microphone
[
UP/DOWN ] key to choose DCS code.
MHZ: In VFO mode, press the key programmed as MHZ function, the
megabit digital in the LCD flashes, now turn the channel knob or
microphone [ UP/DOWN ] key to adjust frequency by 1Mhz step. In
channel mode, press this key, the channel number ashes, now adjust
selector knob or microphone [ UP/DOWN ] key
to adjust channel.
The PA, PB, PC, PD, keys are programmable, they can be endowed with
the following functions.
RPTR: OFFSET direction setup, in standby,
press the key programmed as RPTR function
will change the offset direction. When LCD displays"+", means plus offset,
when the LCD displays"-", means minus offset.
NOTE
PTT
Main/Sub band switch
UP
DOWN
MIC
Numeric Keys
UP/DOWN lock key
Microphone speaker
To Next Page