EasyManua.ls Logo

Cillit Access 10 - User Manual

Cillit Access 10
25 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Important notice: Always keep the tting and operating instructions close
at hand to avoid any mistakes and before carrying out any work on the
device you should read the tting and operating instructions carefully and
follow them. While our data sheets and brochures should provide advice to
the best of our knowledge, the content thereof is not legally binding.
Changes of technical details are reserved!
Wichtige Hinweise: Um Fehler zu vermeiden, ist die Einbau- und Bedie-
nungsanleitung stets griffbereit aufzubewahren, vor der Ausführung von Ar-
beiten am Gerät vollständig durchzulesen und zu beachten. Unsere Merk-
blätter und Druckschriften sollen nach bestem Wissen beraten, der Inhalt ist
jedoch ohne Rechtsverbindlichkeit. Im Übrigen gelten unsere allgemeinen
Geschäftsbedingungen.
Änderungen bei technischen Details sind vorbehalten!
Cillit-GD 03-10001 / Rev. 1.03 – EN, DE / CIL10-25 / 2012-09
BWT UK Limited.
Cillit
®
Access
Domestic water softener
10, 15, 20, 25
Weichwasseranlage
10, 15, 20, 25
Fitting and operating
instructions EN
Einbau- und
Bedienungsanleitung DE
OPM - Cillit Access 10-25 vOrange - EN, DEv4.indd 1 02/10/2012 09:48

Table of Contents

Questions and Answers

  • J
    Jennifer DuncanAug 11, 2025
    What to do if my Cillit Water Dispenser shows the “SALt“ error code?
    • A
      Amanda LindseyAug 11, 2025
      If the Cillit Water Dispenser displays the error code “SALt“, refill the brine cabinet with salt. You can also reset the salt alarm to full capacity by pressing the [SET] key.
  • M
    Melissa HuangAug 16, 2025
    Why is my Cillit Water Dispenser using excessive salt?
    • S
      Samantha WashingtonAug 17, 2025
      If your Cillit Water Dispenser is using too much salt, check the hardness setting and reduce it if it's incorrect.
  • J
    Jacqueline Marshall DDSAug 23, 2025
    What to do if the digital display on my Cillit Water Dispenser is blank?
    • S
      Stacey PerezAug 23, 2025
      If the digital display of your Cillit Water Dispenser is blank, check that the power is turned on and all connections are secure.
  • C
    Cynthia RamirezAug 29, 2025
    How to fix no water coming from my Cillit Water Dispenser?
    • J
      Jessica GreenAug 29, 2025
      If there is no water coming from your Cillit Water Dispenser, make sure the mains stop valve is open. Also, check that the inlet and outlet valves to the water softener are open.
  • J
    John OrtizSep 4, 2025
    Why does water constantly run from the drain of my Cillit Water Dispenser?
    • R
      ryan22Sep 4, 2025
      If water runs from the drain constantly in your Cillit Water Dispenser during recharge, this is normal; wait until the recharge is complete. There should be no flow to drain in the service position.

Cillit Access 10 Specifications

General IconGeneral
ModelAccess 10
Power Consumption (heating)500W
Voltage220-240V
Frequency50/60Hz
TypeWater Dispenser
Heating Capacity5 liters/hour