CipherLab 8400 Series

60
STREAM Wireless Studio User Guide
2.2 LOGIN/LOGOUT
2.2.1 SETTINGS
Go to System Menu > Set STREAM Server. The communication settings and login prompt can only
be changed in the STREAM Designer as shown below.
 The default Telnet port is 6000. Make sure you use the same port number on the
mobile computer. Refer to section 1.5.3 Wireless LAN
.
 The new settings will take effect after restarting the STREAM Server.
Warning: The server IP address and Telnet port number can be modified on the
mobile computer directly.
2.2.2 LOG IN
8000/8300/8400/8500 SERIES
1) When you turn on the mobile computer (or click the [Power] key on the Simulator),
the Main Menu will be displayed.
2) Select [1. Telnet] to start a telnet session. The login screen is displayed as shown
below.