CipherLab 8630 User Manual

61
The tables below list reader settings as well as symbology settings for the CCD or Laser
scan engine.
READER SETTINGS TABLE
CCD/Laser Engine
Description
Default
Scan Mode Laser mode
Continuous Mode Non-stop scanning

To decode the same barcode repeatedly, move away the scan beam
and target it at the barcode for each scanning.
Test Mode Non-stop scanning
 Capable of decoding the same barcode repeatedly
Repeat Mode Non-stop scanning
 Capable of re-
transmitting barcode data if triggering within one second
after a successful decoding
Momentary Mode Hold down the scan trigger to start with scanning.
 The scanning won't stop until you release the trigger.
Alternate Mode Press the scan trigger to start with scanning.
 The scanning won't stop until you press the trigger again.
Aiming Mode
Press the scan trigger to aim at a barcode. Within one second, press the
trigger again to decode the barcode.
 The scanning won't stop until (a) a barcode is decoded, (b) the pre-
set
timeout expires, or (c) you release the trigger.
Laser Mode Hold down the scan trigger to start with scanning.
 The scanning won't stop until (a) a barcode is
read, (b) the preset
timeout expires, or (c) you release the trigger.
Auto Off Mode Press the scan trigger to start with scanning.
 The scanning won't stop until (a) a barcode is read or (b) the preset
timeout expires.
Auto Power Off Mode Press the scan trigger to start with scanning.

The scanning won't stop until the preset timeout expires, and, the
preset timeout period re-counts after each successful decoding.
Read Redundancy None
None No redundancy means one successful decoding will make the reading
valid
and induce the "READER Event".
Appendix II
CCD/LASER SCAN ENGINE

CipherLab 8630 Specifications

General

Brand	CipherLab
Model	8630
Category	Handhelds
Language	English