70
Wireless Smart Scan User Guide
Time-out 3 sec.
0~255 (second) Set the maximum time for decoding to continue during a scan attempt.
It applies to the following scan modes only –
Aiming mode
Laser mode
Auto Off mode
Aiming Duration 3 sec.
1~255 (second) Set the maximum time for aiming to continue before a scan attempt.
It applies to Aiming mode only.
Picklist Mode
Picklist mode enables the decoder to decode only barcodes
aligned under the center of the laser aiming pattern.
Enable
Disable
Disable
1D Inverse Decode 1D Inverse Decoder:
Decode regular 1D barcode only
Decode inverse 1D barcode only
Decode both regular and inverse
Decode
barcode only
Mobile Display Mode Decide whether to enable mobile phone display
Enable
Disable
Disable
Read Redundancy None
None
No redundancy means one successful decoding will make the reading valid
and induce the "READER Event".
One time or Two times
The higher the reading security is (that is, the more redundancy the user
selects), the slower the reading speed gets.
If "Two Times" is selected, it will take a total of three
successful decodings of the same barcode to make the reading valid.
To Next Page
Loading...
Need help?
General
