READ AND FOLLOW ALL INSTRUCTIONS
All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
Improper use or installation can badly harm the unit and its surroundings. When installing and using electrical
equipment, basic safety precautions should always be followed, including the following:
• DANGER Disconnect all AC power before installation.
• Device can be connected / disconnected to / from power supply by plug or circuit breaker.
• WARNING – to reduce the risk of injury, do not permit children to use this product, unless they are
closely supervised at all times.
• Unit must be mounted at a minimum horizontal distance of 5 ft (or more, if local codes require so) from
the inside walls of the swimming pool.
• WARNING – risk of electric shock! Connect only to a grounding type circuit protected by a ground-fault
circuit-interrupter (GFCI) outlet. The installer should provide this GFCI requirement. The GFCI should be
rated for minimum 6 Amps and tested on a regular basis by pushing the test button. If the GFCI fails to
operate correctly, there is ground current flowing indicating the possibility of electric shock. Do not use
this unit. Disconnect unit and have a qualified professional fix the problem before operating again.
• A wire connector is provided to this unit to connect a minimum No. 8 AWG solid copper conductor
between this unit and any metal equipment, metal enclosures of electrical equipment, metal water
pipe, or conduit within 5 feet of the unit.
• DANGER - Risk of electric shock! Install at least 5 feet from all metal surfaces. As an alternative, this
unit may be installed within 5 feet of metal surfaces, if each metal surface is permanently connected by
a minimum No. 8 AWG solid copper conductor to the wire connector on the terminal box that is
provided for this purpose.
• WARNING! To reduce the risk of electric shock, DO NOT turn on or operate the unit if the cell housing
is damaged or improperly assembled!
• WARNING! To reduce the risk of electric shock, replace a damaged cord immediately. WARNING - RISK
OF ELECTRIC SHOCK!
• WARNING! To reduce the risk of electric shock, do not use an extension cord to connect the unit to
electric power supply; provide a properly located outlet. Do not bury cord!
• Wiring of the unit must be performed according to the wiring instructions detailed in this manual.
• Ensure that equipment and materials used in or around the pool and spa are compatible with salt-
based sanitation systems. Certain materials may be susceptible to salt and chlorine damage.
• If acid is stored in the machine room, make sure it is properly vented to avoid damage from acid
vapors.
• Under no circumstances should the machine room be used to store equipment, furniture, sports gear
or any other apparatus that is not related to the pool including spare acid containers. The machine
room must be aired and vented prior to working in it.
• Device is suitable for IP66 environment conditions.
• Device is suitable for voltage range of 100-240Vac, 50-60Hzm current rating 4A.
• Device should be installed at maximum operating temperature of 40°C, Pollution Degree 2, Installation
Category 2, Altitude up to 2000m, Indoor/Outdoor, Wet locations
• SAVE THESE INSTRUCTIONS.
To Next Page
Loading...
