7
Adding Salt
IMPORTANT: Before adding salt at any time, ALWAYS perform an independent water test to measure pre-existing salt levels.
After measuring for any existing salt content in the pool, add salt according to the chart above. The chart allows you to
cross-reference your existing salt level and your pool size to estimate the number of pounds of salt required to achieve
3500 ppm. Without the right amount of salt, the result will be reduced efficiency and a low level of chlorine production.
In addition, operation at low salt levels will reduce the longevity of the cell.
When adding the salt to the pool, it is best to empty the required salt into the shallow end of the pool and run the filter
and pump simultaneously in order to circulate the water and dissolve the salt (the EDGE
-
Series is to remain off during this
time period). Do not throw the salt bag into the water as chemicals and inks on the bag can interfere with water balance.
Salt may take 24 - 48 hours to dissolve in summer, and longer in winter. Finer granules of salt will dissolve faster than
compressed pellets.
The salt in your pool is constantly recycled and does not normally need to be replenished frequently. The loss of salt
throughout the swimming season should be small, and is due primarily to the addition of extra water to replace water lost
from splashing, backwashing, and draining. Salt is not lost due to evaporation.
Use only evaporated, granulated, non-iodized salt (Sodium Chloride). The purer the salt (at least 99%), the better the life
and performance of the Electrolytic Cell. Water Softener salt (also known as Water Conditioning pellets) is an economical
way to buy large quantities of salt. However, only salt that is at least 99% pure NaCl can be used. Pellets are compressed
forms of evaporated salt that may take longer to dissolve. Avoid using salt with anti-caking agents (Sodium Ferrocyanide,
also known as YPS or Yellow Prussiate of Soda) that could cause discoloration of fittings and surface finishes in pool. Do
not use Calcium Chloride as a source of salt. Do not use Rock Salt; insoluble impurities mixed with the rock salt can shorten
the life of the unit.
TIP: When adding large quantities of salt, independently test the existing salt level and add in portions, retesting at each stage.
To Next Page
Loading...
