Circutor RGU-10 B - 3�3�- Terminals of the Device

10
RGU-10 B, RGU-10 B RCM
Instruction Manual
3.- The front frame is attached to cover the mounting points.
4.- Three green pressure tabs on the side runners of the base are attached.
5.- The device is mounted in the hole in the panel with the adapter.
6.- The tabs run towards the panel to obtain the mounting pressure.
Figure 2: Installation of adapter accessory.
3.3.- TERMINALS OF THE DEVICE
Table 3:Terminal description RGU-10 B.
Terminals of the device
1: External input trip - Reclose 9: Transformer input 1S2
2: External input trip - Reclose 10: Power supply
4: Prealarm relay (Common) 11: Power supply
5: Prealarm relay (NC) 13: Tripping relay (NO)
6: Prealarm relay (NO) 14: Tripping relay (NC)
8: Transformer input 1S1 15: Tripping relay (Common)
8 9
1 2 4
5 6
10
11
13
14
15
Reset
Test
B
Figure 3:Terminals RGU-10 B.