Need help?Do you have a question about the Circutor CVMk Series and is the answer not in the manual?
General| Input Current | 5 A |
|---|---|
| Display | LCD |
| Communication | RS-485 (Modbus/RTU) |
| Power Supply | 85...265 V AC/DC |
| Measurements | Voltage, current, power, energy |
| Frequency Range | 45-65 Hz |
| Operating Temperature | -10...+50 ºC |
| Storage Temperature | -25°C to +70°C |
| Relative Humidity | Up to 95% (non-condensing) |
| Protection Degree | IP20 (Terminals) |
| Dimensions | 96 x 96 mm |
Details pre-connection checks for voltage supply, maximum measuring voltage, and current.
Provides warnings and checks before applying AC power, including supply voltage details.
Illustrates the wiring diagram for the standard CVMk in a low voltage, three-phase network.
Shows the wiring diagram for the CVMk-ITF in a low voltage, three-phase network, noting specific remarks.
Details how to configure the demand period and control parameter for maximum power demand.
Lists commands to read electrical parameters like voltage, current, power, and frequency.
Details commands used for programming and configuring the CVMk device settings.
Commands related to setting and reading maximum power demand values and periods.
A single command to retrieve all available electrical parameters from the CVMk.
Describes the MODBUS protocol implementation, RTU mode, and available functions.
To Next Page
