Need help?Do you have a question about the Circutor CVM-C10 and is the answer not in the manual?
General| Power Measurement | Active, reactive, and apparent power |
|---|---|
| Frequency Measurement | 45 - 65 Hz |
| Display Type | LCD |
| Communication Protocol | Modbus RTU |
| Measurement Category | CAT III 300 V |
| Safety Standards | IEC 61010-1 |
| Weight | Approx. 250 g |
| Mounting Type | DIN rail |
| Accuracy | Class 0.5 |
| Power Supply | 85 - 265 V AC/DC |
Warns of a risk, which could result in personal injury or material damage.
Safety measures and qualified staff for installation.
Panel mounting and connection requirements.
Measuring currents with flexible sensors.
Diagram for 4-wire, 3-phase measurement.
Diagram for 4-wire, 3-phase measurement with ITF-IN.
Diagram for 4-wire, 3-phase measurement with MC model.
Diagram for 4-wire, 3-phase measurement with FLEX model.
Diagram for 3-wire, 3-phase measurement.
Diagram for 3-wire, 3-phase measurement with MC model.
How to program the primary voltage transformer ratio.
How to program the secondary voltage transformer ratio.
How to program the primary current transformer ratio.
How to select the secondary current transformer for ITF models.
How to program primary neutral current.
How to select secondary neutral current for ITF-IN.
How to select the device's operation profile.
How to program alarm relay 1.
How to set the maximum value for alarms.
How to set the minimum value for alarms.
How to program alarm relay 2.
How to program digital output T1.
How to program digital output T2.
How to select the RS-485 protocol.
Configuration settings for Modbus protocol.
Configuration settings for BACnet protocol.
How to lock/unlock the programming menu.
Modbus memory map for alarms 1 and 2.
Modbus memory map for alarms 3 and 4.
Modbus memory map for communications settings.
To Next Page
