to modify the other values.
If you press the
key after changing the last digit, it will jump back to the rst digit so you
can modify the previously programmed values again.
Press key
to browse the different tariffs.
To validate the data, press
for 3 seconds and the prog icon will disappear from the display.
The programmed value will be deleted if the entered value is higher than the maximum
programming value.
Maximum programming value: 1.9999.
Minimum programming value: 0.
Press key
to access the next programming step.
4.9.22. COST RATIO OF CONSUMED ENERGY
The cost per kWh of electricity of the three tariffs of the unit is
calculated on this screen.
Press key
for 3 seconds to edit the cost ratio selection. The
prog icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly,
increasing the value of the ashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to modify the other values.
If you press the
key after changing the last digit, it will jump back to the rst digit so you
can modify the previously programmed values again.
Press key
to browse the different tariffs.
To validate the data, press
for 3 seconds and the prog icon will disappear from the display.
The programmed value will be deleted if the entered value is higher than the maximum
programming value.
Maximum programming value: 1.9999.
Minimum programming value: 0.
Press key
to access the next programming step.
57
To Next Page
Loading...
Need help?
General
