To complete the validation, press the key for 3 seconds; the prog icon will disappear from
the display.
Press key
to access the next programming step.
4.9.18. ACTIVATING THE HARMONICS DISPLAY SCREEN.
This screen is used to select whether harmonics are displayed
or not.
Press key
for 3 seconds to edit the selection. The prog icon
will be displayed on the bottom of the screen.
Press key
to browse the two options (Yes and No).
To validate the data, press
for 3 seconds and the prog icon will disappear from the display.
Press key
to access the next programming step.
4.9.19. kgC0
2
CARBON EMISSION RATIO OF GENERATED ENERGY
The carbon emissions ratio is the amount of emissions released
into the atmosphere to produce a unit of electricity (1 kWh).
The ratio for the European mix is approximately 0.65 kgCO
2
per
kWh.
Press key
for 3 seconds to edit the emission ratio selection.
The prog icon will be displayed on the bottom of the screen.
The emission ratio of the 3 tariffs of the device, T1, T2 and T3, is programmed on this screen.
To enter or modify the value, press the
key repeatedly, increasing the value of the ashing
digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to modify the other values.
If you press the
key after changing the last digit, it will jump back to the rst digit so you
can modify the previously programmed values again.
Press key
to browse the different tariffs.
To validate the data, press
for 3 seconds and the prog icon will disappear from the display.
The programmed value will be deleted if the entered value is higher than the maximum
programming value.
Maximum programming value: 1.9999.
Minimum programming value: 0.
55
To Next Page
Loading...
Need help?
General
