4.9.29.2 BACnet protocol
Note : Protocol available in devices with version 3.00 or higher.
Transmission speed
The transmission speed of BACnet communications is
programmed on this screen.
Press key
for 3 seconds to edit the transmission speed
selection. The prog icon will be displayed on the bottom of the
screen.
Press key
to browse the two options: 9600 or 19200.
To validate the data, press
for 3 seconds and the prog icon will disappear from the display.
Press key
to access the next programming step.
Device ID
The device ID is programmed on this screen.
Press the
key for 3 seconds to edit the value. The prog icon
will be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly,
increasing the value of the ashing digit.
When the desired value is shown on the screen, press the
key to go to the next digit and
modify the other values.
If you press the
key after changing the last digit, it will jump back to the rst digit so you
can modify the previously programmed values again.
Maximum programming value: 999999.
Minimum programming value: 0.
To validate the data, press
for 3 seconds and the prog icon will disappear from the display.
Press key
to access the next programming step.
69
To Next Page
Loading...
