----- Supply network analyzer CVMk and CVMk-ITF ------ Page Nº 17
max
Pressing the "max" key, the maximum values for the parameters being shown
appear in the displays.
This function is only valid while you keep pressing the "max" key. If you stop
pressing the key the instantaneous values appear again.
When showing maximum values the LED indicators remain blinking.
min
Pressing the "min" key, the minimum values for the parameters being shown
appear in the displays.
This function is only valid while you keep pressing the "min" key. If you stop
pressing the key the instantaneous values appear again.
When showing minimum values the LED indicators remain blinking.
Reset
Pressing the "reset" key the system is reset. This is equivalent to switch off the
power supply of the instrument.
The stored maximum and minimum values will be automatically deleted from the
internal memory.
If you are in the setup process and press the "reset" key, you exit it without saving
any modification that you have done and making a reset of the system.
To Next Page
Loading...
Need help?
General
