Circutor URBAN - Firmware Upgrade Process

URBAN DC
31
Installation Guide
Need help?
In case of any query in relation to device operation or malfunction, please contact the
CIRCUTOR, SA Technical Support Service.
Technical Assistance Service
Vial Sant Jordi, s/n, 08232 - Viladecavalls (Barcelona)
Tel: 902 449 459 (Spain) / +34 937 452 919 (outside of Spain)
email: sat@circutor.com
Guarantee
CIRCUTOR guarantees its products against any manufacturing defect for two years after
the delivery of the devices.
CIRCUTOR will repair or replace any defective factory product returned during the guar-
antee period.
• No returns will be accepted and no device will be repaired or replaced if it
is not accompanied by a report indicating the defect detected or the reason
for the return.
•The guarantee will be void if the devices has been improperly used or the
storage, installation and maintenance instructions listed in this manual have
not been followed. “Improper usage” is defined as any operating or storage
condition contrary to the national electrical code or that surpasses the limits
indicated in the technical and environmental features of this manual.
• CIRCUTOR accepts no liability due to the possible damage to the device
or other parts of the installation, nor will it cover any possible sanctions
derived from a possible failure, improper installation or “improper usage” of
the device. Consequently, this guarantee does not apply to failures occurring
in the following cases:
- Overvoltages and/or electrical disturbances in the supply;
- Water, if the product does not have the appropriate IP classification;
- Poor ventilation and/or excessive temperatures;
- Improper installation and/or lack of maintenance;
- Buyer repairs or modifications without the manufacturer’s authorisation.