URBAN DC
7
Installation Guide
This manual provides commissioning and use instructions information about URBAN
DC, which has been designed and tested to allow electric vehicle charging, specified
in IEC 61851.
This document has different sections such as step-by-step installation procedure
and technical data.
ELECTRIC RISK
Take precautions to make the electrical connection inside the unit. Unit
must be disconnected from any power source during commissioning.
ATTENTION!
Indicates that the damage to property can occur if appropiate
precautions are not taken.
So, hello!
THE FOLLOWING SYMBOLS ARE USED FOR IMPORTANT
SAFETY INFORMATION IN THIS DOCUMENT
• Compliant with IEC 61851; Electric vehicle conductive charging system (IEC 61851-1 and
IEC 61851-23).
• Compliant with IEC 62196; Plugs, sockets-outlets, vehicle connectors and vehicle inlets-
Conductive charging of electric vehicles (IEC 62196-1, IEC 62196-2 and IEC 62196-3).
• Directives: 2014/53/UE, Radio and Telecommunication Terminal equipment; 2014/30/
UE, Electromagnetic Compatibility (EMC); 2014/35/UE, Low Voltage.
• Compliant with IEC 61851-24, Digital communication between a DC EV charging station
and an electric vehicle for control of DC charging. Meets the CCS specification, DIN
SPEC 70121. ISO 15118 ready.
• Compliant with RoHS 2011/65/EU-2017/2102, Restriction of Hazardous Substances.
• RFID complies with ISO 14443A/B, Identification cards- Contactless integrated circuit
cards- Proximity cards.
• Modem 4G complies with CE/RED
To Next Page
Loading...
