URBAN DC
8
Installation Guide
Important Safety Instructions
2
Refer to TECHNICAL DATA section for more information about environmental installation conditions.
The Charge Point is designed for installation at indoor and outdoor areas. For each of the
different conditions of installation, the unit must be installed safely and ensure adequate
protection.
• Charge Point must not be installed in
areas where there is potential risk of
explosion or any salinity level.
• Charge Point must not be installed
in industrial areas with high level of
humidity or pollutants.
• Do not install the Charge Point where
falling objects may damage the
equipment.
• The surface where the Charge
Point is placed must withstand the
mechanical forces.
• Do not use this unit for anything
other than electric vehicle charging
modes are expected in IEC 61851.
• Do not modify this unit. If modified,
CIRCUTOR will reject all responsibility
and the warranty will be void.
• Comply strictly with electrical safety
regulations according to your country.
• Do not make repairs or manipulations
with the unit energized.
• Only trained and qualified personnel
should have access to the electrical
parts inside the Charge Point.
• Check the installation annually by
qualified technician.
• Remove from service any item
that has a fault that could be
dangerous for users (broken
plugs, caps that don’t close...).
• Use only CIRCUTOR supplied spare
parts.
• Do not use this unit if the enclosure
or the EV connector is broken,
cracked, open, or shows any
Read carefully all the instructions before starting in order
to ensure properly installation of the Charge Point.
A
To Next Page
Loading...
