URBAN - URBAN WB
Instruction Manual
43
Value Description
Stop charge if
StartTransaction replies
ConcurrentTx
YES: Stop existing charge transaction after response from
backend (StartTransaction.conf) when user has already in-
volved in another transaction.
NO: Charge transaction does not stops even if backend re-
jects the user. (StartTransaction.conf)
NOTE: Set this option according to your backend system.
Require auth. At remote
Start
YES: Charge point sends an authorization request before
starting a new remote charge transaction request.
NO: Charge point starts a new remote charge transaction
without authorization request.
Active Power in
MeterValues
YES: Send power (Power.Active.Import) and energy (Energy.
Active.Import.Register) consumed by the vehicle within meter
values requests.
NO: Only energy consumed is sent within meter values re-
quest.
Heartbeat interval Heartbeat send interval (in seconds) for the back-end system.
Connection timeout Timeout (in seconds) before connecting to the central system.
Meter value sample
interval
Meter value sample send interval (in seconds) during charge
transaction.
NOTE: Meter values are disabled if 0 seconds is set
To Next Page
Loading...
