EasyManua.ls Logo

Cirrus DESIGN SR20 - Section 4 Normal Procedures

Cirrus DESIGN SR20
392 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P/N 13999-002 Info Manual 4-27
Cirrus Design Section 4
SR20 Normal Procedures
(Continued on following page)
11. Power Lever ............................................................ OPEN ¼ INCH
12. Ignition Switch....................... START (Release after engine starts)
• Caution •
Limit cranking to intervals of 20 seconds with a 20 second
cooling period between cranks. This will improve battery and
contactor life
13. Power Lever ...............................RETARD (to maintain 1000 RPM)
14. Oil Pressure ....................................................................... CHECK
15. Alt Master Switches ...................................................................ON
16. Vacuum System Annunciators ................................................ OUT
17. Avionics Power Switch ...............................................................ON
18. Engine Parameters ........................................................ MONITOR
19. External Power (If applicable) ................................. DISCONNECT
20. Amp Meter/Indication......................................................... CHECK
21. Strobe Lights..............................................................................ON
Hot Weather Operation
Avoid prolonged engine operation on the ground.
• Note •
Fuel BOOST should be left ON during takeoff and for climb as
required for vapor suppression with hot or warm fuel.
September 2011

Table of Contents

Other manuals for Cirrus DESIGN SR20

Related product manuals