Cirrus DESIGN SR20 - Ground Emergencies; Default Chapter; Emergency Engine Shutdown on Ground; Engine Fire During Start

P/N 13999-002 Info Manual 3-7
Cirrus Design Section 3
SR20 Emergency Procedures
Ground Emergencies
Engine Fire During Start
A fire during engine start may be caused by fuel igniting in the fuel
induction system. If this occurs, attempt to draw the fire back into the
engine by continuing to crank the engine.
1.
Mixture ..............................................................................CUTOFF
2. Fuel Pump ...............................................................................OFF
3. Fuel Selector............................................................................ OFF
4. Power Lever ..................................................................FORWARD
5. Starter ............................................................................... CRANK
6. If flames persist, perform Emergency Engine Shutdown on
Ground and Emergency Ground Egress checklists.
Emergency Engine Shutdown On Ground
1. Power Lever ............................................................................ IDLE
2. Fuel Pump (if used) .................................................................OFF
3. Mixture ..............................................................................CUTOFF
4. Fuel Selector............................................................................ OFF
5. Ignition Switch..........................................................................OFF
6. Bat-Alt Master Switches...........................................................OFF
September 2011