6 of 16 P/N 11934-S13
Section 9 Cirrus Design
Supplements SR20
Section 3 - Emergency Procedures
Autopilot Malfunction
Refer to Electric Trim/Autopilot Failure procedure in the SR20 POH. Do
not reengage the autopilot until the malfunction has been identified
and corrected. The autopilot may be disconnected by:
1. Pressing the A/P DISC/Trim switch on the control yoke handle.
2. Pulling the AUTOPILOT circuit breaker on Essential Bus.
Altitude lost during a roll axis autopilot malfunction and recovery:
Altitude lost during a pitch axis autopilot malfunction and recovery:
Flight Phase Bank Angle Altitude Loss
Climb 30° None
Cruise 55° 100 ft
Descent 55° 120 ft
Maneuvering 10° None
Approach 0° 20 ft
Flight Phase Altitude Loss
Cruise 200 ft
ILS 25 ft
Revision 04: 08-15-07
To Next Page
Loading...
