Cirrus SR20 - Before Engine Start; Passenger Flight Briefing

3-16 P/N 23020-002
Cirrus SR20 and SR22 Flight Operations Manual
Section 3 Standard Operating Procedures
Before Engine Start
Complete the Before Starting Engine checklist as a Do-List to start the
aircraft engine. Before starting the engine verify all preflight items are
complete and all emergency equipment is on board and stored in the
proper location. Remove the CAPS pin after all occupants have
boarded the aircraft and are seated with seat belts fastened. Ensure
seats are locked into position by verifying the control handle is in the
full down position.
During engine start the aircraft should be positioned so that the
propeller blast will not adversely affect any aircraft, hangar, or person.
Passenger Flight Briefing
The pilot should provide a safety briefing, referencing the Passenger
Briefing Card, to all passengers prior to each flight. The briefing shall
provide instructions in the event of a pilot incapacitation including the
use of the CAPS, seat belts, exits, and any other safety equipment on
the aircraft. The pilot should also discuss sterile cabin procedures and
other information as necessary.
At a minimum, passengers should be briefed on the following items;
• CAPS,
•Smoking,
• Seatbelts,
•Doors,
• Emergency Exits/Egress Hammer,
• Use of Oxygen.
June 2008