P/N 23020-002 3-23
Cirrus SR20 and SR22 Flight Operations Manual
Section 3 Standard Operating Procedures
Procedure (Flow Pattern)
1. Flaps ................................................................................. UP (0%)
Visually verify flaps are in the 0% position and flap position light
UP is illuminated.
2. Radios/Avionics ..................................................... AS REQUIRED
Ensure all radios and avionics are programmed, navigation
frequencies identified, courses set and with required waypoints or
flight plans loaded.
3. Cabin Heat/Defrost ................................................ AS REQUIRED
4. Fuel Selector...........................................................SWITCH TANK
Switch tank to ensure positive fuel flow from both fuel tanks.
Avionics Configuration
• Audio Panel ................................... Select COM AS REQUIRED
Ensure desired communication are selected. Adjust intercom
volume as required.
• Autopilot .................................................................... Verify OFF
Verify the autopilot is not engaged and yaw damper is off.
• GCU/MFD/PFD ................. SET COM and FPL AS REQUIRED
Initialize the MFD and verify database currency. Construct flight
plan as required and set applicable communication and
navigation frequencies.
• MFD...................................................................... CONFIGURE
Adjust MAP page range to display Safe Taxi. Select Chartview
to view the airport diagram if Safetaxi in not available for the
airport if applicable.
• PFD ................................................................ VERIFY and SET
Verify PFD is fully aligned and select the traffic display on PFD
inset display.
June 2008
To Next Page
Loading...
