P/N 23020-002 3-47
Cirrus SR20 and SR22 Flight Operations Manual
Section 3 Standard Operating Procedures
Procedure (Flow Pattern)
1. Seat Belt and Shoulder Harness .........................................Secure
Ensure the seat belt and shoulder harness is secure for all
occupants in the aircraft.
2. Fuel Pump ......................................................................... BOOST
3. Mixture ................................................................... AS REQUIRED
SR20 - Mixture full rich for all altitudes.
SR22 - Mixture as required for altitude. Reference the max power
fuel flow placard for mixture setting. Avoid rich mixture settings at
high elevations.
SR22 Turbo - Mixture full rich for all altitudes.
4. Flaps ...................................................................... AS REQUIRED
Reference the Traffic Pattern Profile or Approach Profile for
information on the appropriate use of flaps
5. Autopilot ................................................................. AS REQUIRED
It is recommended to disconnect the autopilot prior to entering the
traffic pattern. If applicable, ensure Yaw Damper is off prior to
landing.
Avionics Configuration
• Autopilot - Disengage the autopilot prior to entering the traffic
pattern, verify the yaw damper is disconnected
• MFD - Complete the Before Landing Checklist, monitor Map for
situational awareness.
• PFD Monitor aircraft flight parameters
June 2008
To Next Page
Loading...
