Statement 407—Japanese Safety Instruction
You are strongly advised to read the safety instruction before using the product.
https://www.cisco.com/web/JP/techdoc/pldoc/pldoc.html
When installing the product, use the provided or designated connection cables/power cables/AC adapters.
Note
Statement 1005—Circuit Breaker
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: AC 20 A/DC 40 A
Warning
Statement 1015—Battery Handling
To reduce risk of fire, explosion or leakage of flammable liquid or gas:
• Replace the battery only with the same or equivalent type recommended by the manufacturer.
• Do not dismantle, crush, puncture, use sharp tool to remove, short external contacts, or dispose of in fire.
• Do not use if battery is warped or swollen.
• Do not store or use battery in a temperature > 60° C.
• Do not store or use battery in low air pressure environment < 69.7 kPa.
Warning
Statement 1029—Blank Faceplates and Cover Panels
Blank faceplates and cover panels serve three important functions: they reduce the risk of electric shock and
fire, they contain electromagnetic interference (EMI) that might disrupt other equipment, and they direct the
flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates, front covers,
and rear covers are in place.
Warning
Statement 1073—No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
26
Installation Preparation
Installation Warnings
To Next Page
Loading...
Need help?
General
