Cisco 1600 Hardware Installation Guide

Statement 1074—Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Warning
Statement 1089—Instructed and Skilled Person Definitions
An instructed person is someone who has been instructed and trained by a skilled person and takes the necessary
precautions when working with equipment.
A skilled person or qualified personnel is someone who has training or experience in the equipment technology
and understands potential hazards when working with equipment.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1090—Installation by Skilled Person
Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089 for
the definition of a skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1091—Installation by an Instructed Person
Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.
See statement 1089 for the definition of an instructed or skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Safety Recommendations
Observe these safety guidelines:
• Keep the area clear and dust free before, during, and after installation.
• Keep tools away from walkways, where you and others might trip over them.
• Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains that could get caught in the
chassis.
• Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
• Never attempt to lift an object that is too heavy for one person.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
27
Installation Preparation
Safety Recommendations

Cisco 1600 Specifications

General

Type	Router
Connectivity Technology	Wired
Network / Transport Protocol	TCP/IP, IPX/SPX, AppleTalk
Form Factor	Desktop
Power Source	AC adapter
Operating System	Cisco IOS
Routing Protocols	RIP, IGRP
Flash Memory	8 MB
DRAM	16 MB
Data Link Protocol	Ethernet, Fast Ethernet
Remote Management Protocol	SNMP, Telnet
Status Indicators	Power
Features	Firewall protection, DHCP support, NAT support, VPN support
RAM	16 MB
Data Transfer Rate	10 Mbps
Network Technology	Ethernet