Cisco 1600 Hardware Installation Guide

Package Contents
The following figure shows the package contents for the FMC 1600, 2600, and 4600. Note that the contents
are subject to change and your exact contents might contain additional or fewer items.
Figure 1: Package Contents
RJ-45 to DP9-RS232 console cable (Cisco part
number 72-3383-XX)
2Chassis1
RJ-45 to RJ-45 Cat 5 Ethernet cable, yellow six
feet long (Cisco part number 72-1482-XX)
4Cisco rail kit (Cisco part number 800-43376-02)3
Two 10-Gb SFP+ transceivers with cables
Optional for all models; in package if ordered.
6Useful Links Cisco Firepower Management
Center 1600, 2600, and 4600
The steps in the Useful Links document send you
to the documentation you need to install, set up,
and configure your FMC.
5
Serial Number Locations
The serial number (SN) for the FMC 1600, 2600, and 4600 is printed on the pullout asset card located on the
front panel as shown in the following figure of the FMC 1600.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
4
Overview
Package Contents

Cisco 1600 Specifications

General

Type	Router
Connectivity Technology	Wired
Network / Transport Protocol	TCP/IP, IPX/SPX, AppleTalk
Form Factor	Desktop
Power Source	AC adapter
Operating System	Cisco IOS
Routing Protocols	RIP, IGRP
Flash Memory	8 MB
DRAM	16 MB
Data Link Protocol	Ethernet, Fast Ethernet
Remote Management Protocol	SNMP, Telnet
Status Indicators	Power
Features	Firewall protection, DHCP support, NAT support, VPN support
RAM	16 MB
Data Transfer Rate	10 Mbps
Network Technology	Ethernet