460026001600Feature
Before January 2021:
Eight 16-GB
DDR4-2400-MHz
DIMMs
After January 2021: Eight
16-GB DDR4-2933-MHz
DIMMs
Before January 2021:
Four 16-GB
DDR4-2400-MHz
DIMMs
After January 2021: Four
16-GB DDR4-2933-MHz
DIMMs
Before January 2021:
Two 16-GB
DDR4-2400-MHz
DIMMs
After January 2021: Two
16-GB DDR4-2933-MHz
DIMMs
RDIMMs
Internal component only;
not field-replaceable
Two built-in RJ-45 SFP+ ports
Support for 1000 Mbps, 1 Gbps, and 10 Gbps
The primary management port is eth0. You can use eth1, eth2, and eth3 as
secondary management or event ports.
Management ports
Two USB 3.0 Type AUSB ports
One 3-row 15-pin DB-15 connector
Enabled by default
VGA port
Two fixed SFP+ portsSFP ports
SFP-10G-SR (10 Gb)
SFP-10G-LR (10 Gb)
Only these two SFPs have been qualified for use on the FMC.
Although non-Cisco SFPs and other Cisco SFPs are allowed, we
do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any
interoperability problems that result from using an untested SFP
transceiver.
Note
Supported SFP+
RJ-45 serial port running RS-232 (RS-232D TIA-561)Serial console port
Two 770-W AC power supplies
Hot-swappable and redundant as 1+1
System power
2626 BTU/hrPower consumption
Six fans for front-to-rear cooling
Internal component only; not field-replaceable
Fans
Ten 1.2-TB SAS HDDs
RAID 6, hot-swappable
Four 600-GB 10-K SAS
HDDs
RAID 5, hot-swappable
Two 1.2-TB 10-K SAS
HDDs
RAID 1, hot-swappable
Storage
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
3
Overview
Features
To Next Page
Loading...
Need help?
General
