• Emergency shutdown—Press and hold the Power button for four seconds to force the main power off and immediately
enter standby mode.
Remove and Replace a Drive
The drives are hot-swappable. You do not have to shut down the FMC to remove or replace drives.
Note
You cannot add more drives to your FMC. You can only replace the drives in the slots that are supported for
your model. See Front Panel, on page 6 for the drive configurations.
Note
Safety Warnings
Take note of the following warnings:
Statement 1028—More Than One Power Supply
This unit might have more than one power supply connection. To reduce risk of electric shock, remove
all connections to de-energize the unit.
Warning
Statement 1073—No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1089—Instructed and Skilled Person Definitions
An instructed person is someone who has been instructed and trained by a skilled person and takes the
necessary precautions when working with equipment.
A skilled person or qualified personnel is someone who has training or experience in the equipment
technology and understands potential hazards when working with equipment.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
36
Installation, Maintenance, and Upgrade
Remove and Replace a Drive